|
Post by jordan sutton on Jan 3, 2007 17:27:16 GMT
1.unscrew the 5 screws in his head and open his head up. 2. find the 4 pins on the circuit board of the camera. 3. solder one wire to each outer pin(you should have one wire on the right outer pin and one on the left. 4. on the end of the two wires solder the two wires to the two pins of the L.E.D.5. you can add casing to the wire if you wish to hide the wire.6.close his head back up leaving the rest of the wire sticking out of the hole in his head where the back panel goes.6. fix the back panel tightly on
|
|